Skip to main content

Current regulations

Dental practices in King County that discharge waste into the sewage system must comply with King County discharge limits and Environmental Protection Agency (EPA) regulations. In July 2017, the EPA published new regulations for dental offices in the Code of Federal Regulations (40 CFR Part 441).

Amalgam separator compliance

An amalgam separator takes the mercury and other pollutants out of the water that goes down the drain in the dentist’s office. This way both the pollutants and the water can be treated properly to protect the environment.

Most dental offices in King County's compliance area have approved amalgam separator units. Dental offices, including endodontists and some pediatric specialties, are required by EPA regulations (40 CFR Part 441) to submit a one-time compliance report.

The following specialty dentist offices do not need to fill out a compliance form:

  • Oral pathology
  • Oral and maxillofacial radiology and surgery
  • Orthodontics
  • Periodontics
  • Prosthodontics dentists using a mobile unit
All other dental practices must follow these steps to gain and maintain compliance:
  • Install and maintain an amalgam separators in drains

    King County is no longer maintaining a list of approved amalgam separators. If dental practices are using installation of an approved separator to demonstrate compliance with County regulations, King County will only recognize amalgam separators that have been certified as meeting or exceeding ISO-11143 as verified by an ISO-certified testing laboratory. Dental practices must be able to provide a copy of the ISO-11143 certification for their amalgam separator units if requested by King County.

  • Submit a one-time report to certify compliance

    Download the one-time compliance report for dental dischargers form (775KB)

    Compliance report deadlines:

    Existing offices: If you have not submitted your one-time report, please do so now.

    Office transferred to new ownership: Within 90 days

    New dental offices: No later than 90 days after the introduction of wastewater into the sewer

  • Follow the EPA best management practices

    Dental practices must not discharge waste amalgam into a sewer system. This includes, but is not limited to:

    • Dental amalgam from chair-side traps
    • Screens
    • Vacuum pump filters
    • Dental tools
    • Cuspidors
    • Collection devices

    Dental unit water lines, chair-side traps, and vacuum lines that discharge amalgam process wastewater to a sewer system must not be cleaned with oxidizing or acidic cleaners, including but not limited to bleach, chlorine, iodine and peroxide that have a pH lower than 6 or greater than 8.

King County Industrial Waste compliance area

Enter your business' address, including the city, into the search box to determine if your dental practice is in the compliance area.

What you can expect at a dental office inspection

King County Industrial Waste (KCIW) conducts compliance inspections of dental practices that discharge mercury into the King County sewage system. Inspections normally take less than thirty minutes.

During a compliance inspection, the inspector will verify that:

  • The dental office has installed an approved amalgam separator unit or has a valid wastewater discharge permit.
  • The dental office is properly maintaining the amalgam separator, review maintenance records.
  • The dental office has submitted a one-time compliance report to King County Industrial Waste Program. The dental office should have a copy of the completed one-time compliance report available for review during a compliance inspection.
  • The dental office is following the two BMPs as specified in Section 441.30(b) or Section 441.40 and will continue to do so:
    • Waste amalgam including, but not limited to, dental amalgam from chair-side traps, screens, vacuum pump filters, dental tools, cuspidors, or collection devices, must not be discharged to a publicly owned treatment works (e.g., municipal sewage system).
    • Dental unit water lines, chair-side traps, and vacuum lines that discharge amalgam process wastewater to a publicly owned treatment works (e.g., municipal sewage system) must not be cleaned with oxidizing or acidic cleaners, including but not limited to bleach, chlorine, iodine and peroxide that have a pH lower than 6 or greater than 8 (i.e. cleaners that may increase the dissolution of mercury).

Additionally, the inspector will:

Inspection follow-up

KCIW follows up with offices that do not practice the minimum Best Management Practices or who do not have the required paperwork. A typical inspection follow-up includes the completion of an inspection report and an evaluation of the practice's compliance. If the practice is in compliance, no further action is needed. 

An inspector will set up a compliance schedule if major problems are noted during the inspection. If problems are not corrected, King County may proceed using its Enforcement Response Plan.

Why are dental wastewater discharge regulations important?

One of the best indicators of the quality of King County wastewater discharges is the condition of our Loop biosolids, the nutrient-rich fertilizer alternative and natural soil builder created from King County’s wastewater. Loop contains low levels of metals and organic chemicals. These low amounts are thanks to the cooperation our businesses and industries. 

KCIW inspects a portion of the dental offices each year. We monitor that offices have put the required best management practices into effect. The program will continue to track mercury levels in Loop.

Mercury levels in King County Loop biosolids

Efforts to remove mercury from wastewater is one way we are ensuring Loop is high quality. Ninety-five percent of King County dental offices have taken steps to reduce the amounts of mercury and silver discharged to the sewer system. Most offices have installed amalgam separators and followed the best management practices. This effort has contributed to more than a fifty percent reduction in the mercury levels in Loop since 2001.

King County uses 100% of Loop beneficially to improve soils, store carbon, and grow plants on farms and forests.

Graph shows parts per million, or ppm, of mercury in Loop biosolids at three wastewater treatment plants over six time periods. In 1996-2001, average mercury at the plants was between 2.5 and 3 ppm. From then averages decline to a low between .5 and 0.6 in the years of 2020 through 2022. The EPA safety limit for mercury in biosolids is 17 ppm.
The infographic shows how mercury levels have decreased at our plants since KCIW began working with dental offices in 2021.

Dental technical assistance

  • Note: King County is no longer maintaining a list of approved amalgam separators. If dental practices are using installation of an approved separator to demonstrate compliance with County regulations, King County will only recognize amalgam separators that have been certified as meeting or exceeding ISO-11143 as verified by an ISO-certified testing laboratory. Dental practices must be able to provide a copy of the ISO-11143 certification for their amalgam separator units if requested by King County.
  • Your dental office is required to properly handle and dispose of dangerous waste. Learn more about identifying, handling, and, disposing of dangerous waste.

Learn what to do with used amalgam waste, by Local Hazardous Waste Management Program in King County.

Learn what to do with chemicals and disinfectants at Local Hazardous Waste Management Program in King County.

Those in the King County sewer service area may dispose of solutions containing two - four percent glutaraldehyde disinfectant when following the appropriate best management practices.

What to do with your used x-ray fixer by Local Hazardous Waste Management Program in King County includes information about companies that transport dental office waste to licensed treatment, storage, disposal or recycling facilities.
expand_less